Wuxn Print Surface Adhesive
- Ships Out Immediately
- Wuxn Inspection Quality Control
- In stock, ready to ship
- Inventory on the way
This Wuxn print surface adhesive is the perfect solution for improving the adhesion of your 3D prints. Rather than purchasing an entire Wuxn print surface plate, you can simply replace a single side of the print surface with this adhesive.
The application process is straightforward. First, peel off the previous Wuxn print surface adhesive from the spring steel sheet, and then clean the spring steel plate with isopropyl alcohol. For an even better bond, you can apply an optional decal applicator spray.
Next, use a straight edge to install the Wuxn print surface adhesive to the spring steel sheet. Work the surface from the center to the edges until all bubbles are removed. If the decal applicator spray was used, allow the Wuxn print surface adhesive to dry for 24 hours before printing.
- Material: Textured PEI
- Adhesive: High Temperature Easy Peel
- Width: 253.8 mm
- Height: 241 mm
- Thickness: ~0.2 mm